UK Karting - Notice Board (General Karting) : Re: Rotax loom/coil

Notice Board (General Karting)

Re: Rotax loom/coil
Posted by 'alanrr' on 22 Sep 2015 @ 14:57

| View Message Thread | Reply to this message |

alanrrJoined: August 2001
Total Posts: 491
[ View User Profile ]

Ok just took one apart.

Looking at the end of the socket, carefully prise out the little yellow clip using a screwdriver in the slot at the wide end of the clip.

See if you can pull the black grommet out of the end where the broken wire is.

Now looking at the terminal from the end that plugs into the coil, you will see that the metal bit has a small plastic tang that is holding the terminal.

Lift it up with a very small screwdriver far enough to allow you to push the terminal back into the housing.

You will probably have to extend the wire as it will be too short to reattach by soldering but I would just extend it with a small loop of wire.

Don't forget to put the little black grommet on the wire before you solder it all together.

Then just push the terminal back in and replace the yellow clip.

Be sparing with the soldering.

Message Thread:

Rotax loom/coil by 'BombHead' (20 Sep 2015 @ 12:09)

Re: Rotax loom/coil by 'alanrr' (21 Sep 2015 @ 10:39)

Re: Rotax loom/coil by 'BombHead' (21 Sep 2015 @ 16:18)

Re: Rotax loom/coil by 'alanrr' (21 Sep 2015 @ 19:13)

Re: Rotax loom/coil by 'BombHead' (21 Sep 2015 @ 21:32)

Re: Rotax loom/coil by 'alanrr' (21 Sep 2015 @ 22:39)

Re: Rotax loom/coil by 'alanrr' << You are here!

Re: Rotax loom/coil by 'BombHead' (22 Sep 2015 @ 17:13)

Re: Rotax loom/coil by 'alanrr' (22 Sep 2015 @ 18:09)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links