UK Karting - Notice Board (2-Stroke Karting) : Re: W60 engine temp

Notice Board (2-Stroke Karting)

Re: W60 engine temp
Posted by 'richydehav' on 26 Feb 2009 @ 23:00

| View Message Thread | Reply to this message |

richydehavJoined: August 2006
Total Posts: 180
[ View User Profile ]

This is from the Zip guidance notes for setting the Tryton carb. You should note that the MSA do not support the idea of running the engine on a stand/trolley and many clubs do not allow the running of engines in the paddock because of noise.
If your neighbours are deaf or very friendly then you could do this at home!

8) Starting point for settings � how to set carburettor on stand
Remember this is just a guide line, final adjustments will need to be carried out on track
a) Set throttle cable so that butterfly fully shuts when off throttle
b) Cable adjuster on carburettor must be set so that butterfly does not go over centre.
c) When engine is hot set low speed jet between 45 and 65 minutes so that engine only just ticks
over 1750 rpm.
d) Set high jet to 75 minutes, hold engine on full throttle then screw high jet in slowly until engine revs
to approximately 12200 rpm. From this point screw high jet out 3-4 minutes. Final adjustment
must be made on circuit.

Message Thread:

W60 engine temp by 'Farrang' (26 Feb 2009 @ 13:52)

Re: W60 engine temp by 'FooFoo' (26 Feb 2009 @ 14:34)

Re: W60 engine temp by 'jakes93DAD' (26 Feb 2009 @ 14:37)

Re: W60 engine temp by 'Farrang' (26 Feb 2009 @ 15:08)

Re: W60 engine temp by 'FooFoo' (26 Feb 2009 @ 17:02)

Re: W60 engine temp by 'richydehav' << You are here!

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links