The Kartsmart ones seem to be the best , although Tillet now do a version of this . They will need filing / modifying to fit around the sprocket carriers , you can move the l/h engine one in around 1cm to allow more space if reqd . You may have to cut a slant in the r/h one to miss the back of your seat , will need to run the clutch the wrong way round for this . Cannot fit 2 kerbriders inside as chain guides but Prokart engineering do a good set of these up to 73teeth that will fit inside and have a step on one to act as a spacer for you . Alternatively just use one kerbrider , not quite as good but if large sprockets are needed then you dont have much choice . Lastly rig up a safety spring or retaining device as if the cover comes off it will get run over by following karts and it will be destroyed , better it just flaps about butm stays on your chassis !
|
|